My Embedded  |  My EZ-Cart  |  Checkout   
  Home - CCS3.1 Installation & Configuration
Products
 TI DSP JTAG Emulator

 Digital Motion Control Tools

 ARM Evaluation Board

 ARM Processor Board

 JTAG Emulator for ARM

 ARM Single Board Computer

 ARM & Intel XScale JTAG Emulator

 Intel XScale Evaluation Board

 Digital Storage Oscilloscope

 MPEG-4/H.264 Compression Card

 Network Video Server & Decoder
Solutions
  Video Image
barline
  Audio Speech
Support
  TI DSP Tools
barline
  Customer Service
barline
  FAQs
Company
  About Us
barline
  Careers
barline
  Contact Us
Technical Support
TI DSP - XDS510 JTAG Emulator
  • CCS3.1 Installation & Configuration

    • -   Double click "Setup" file of the CCS3.1 and install CCS3.1 following the instructions.

    -   After the installation, two icons "Setup CCSStudio v3.1" and "CCStudio 3.1" as the following picture will     show on the desktop.



    -   Copy 2 files ("Ez-embedded.cfg", "Ez-embedded.dll" from the CD) in the directory "to be copied" and paste     them to the folder ":\CCStudio_v3.1\cc\bin" (CCStudio_v3.1=CCS3.1 default install directory).

    -   Connect the emulator with target board.

    -   Turn on the target board power, and if the emulator′s driver is correctly installed, the red light should be     ON. The red light can be only turned ON if the driver of emulator is successfully installed. Under the     situation that both green light (power) and red light (run) are ON, CCS is ready to operate.

    -   Run "CCStudio3.1" and wait a few seconds for the software to start. The user should see the following     window if the emulator is successfully installed and also emulator, target board and CCS are running well.







    -   The user can now go ahead to program, and burn Flash.


    NOTE:

    The 14-pin JTAG cable must be connected properly; any improper connection may cause permanent damage to the emulator or target board. The 6th hole of the 14-hole socket has been sealed, so the 6th pin of the 14-pin JTAG connector of the target system has to be removed.



    Related Links
  		• Soultion for Driver Installation Failure
  		• Instruction for TMS320C5402 & CCS3.1 Setup
  		• Step-by-Step Illustration of EVM2812 & CCS3.1 Setup
  		• Troubleshooting: Can not Enter CCS3.1
  		• Hardware Connection
    All credit card transactions are secured with 128-bit SSL encryption.

       © 2008 EZ-Embedded. All right reserved.
          Privacy Policy      Terms & Conditions